Waste Ink Tray Assy - Epson Artison 800 Service Manual

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Align the dowels (x2) of the Sub Transmission Cam Holder with the
positioning holes (x2) of the Main Frame. (See
Align the protrusion of the Transmission Arm with the groove
of the Sub Transmission Cam Holder. (See
After installing the Sub Transmission Cam Holder, follow the
procedure below to check the movement of the Sub
Transmission Cam Holder.
1. Slide the switch lever to the 0 digit side to check if the point
A of the Sub Transmission Cam Holder locks the
protrusion of the Transmission Arm, and the arm moves to
the middle.
2. By sliding the switch lever further to the 0 digit side, check
if the lock is released and the Sub Transmission Cam
Holder returns to the regular position when letting go of
the change lever.
Regular position
Switch lever
Protrusion of
Transmission Arm
Sub Transmission Cam Holder
Groove
Figure 4-153. Installing the Sub Transmission Cam Holder
After removing/replacing the Upper Paper Guide L/R, make the
A D J U S T M E N T
R E Q U I R E D
specified adjustments. (See
DISASSEMBLY/ASSEMBLY
Fig. 4-148.)
Fig. 4-153.)
Switch lever
Middle position
Protrusion of
Transmission Arm
Point A
Chapter 5 "ADJUSTMENT".)
Disassembly Procedures
http://www.manuals4you.com

4.2.4.20 Waste Ink Tray Assy

Parts/Components need to be removed in advance:
None
Removal procedure
So as to make description easier, the printer in the photographs
C A U T I O N
is placed vertically in the following steps. Be careful about ink
spilling if the printer is tilted in practical operation.
Be careful not to get injured with the sharp edges of the
grounding plate of the Waste Ink Tray Assy.
1. Remove the screw (x1). (See
2. Insert the flathead screwdriver to the hole of the Rear Right FAX Housing to
release the hook (x1), and remove the Waste Ink Tray Assy. (See
Fig. 4-155.)
Sharp edge
Waste Ink Tray Assy
Figure 4-154. Removing the Waste Ink Tray Assy (1)
Revision C
Fig. 4-154.)
Fig.
Hook in the hole
Flathead screwdriver
C.B.A. 3x10 (6±1Kgfcm)
Confidential
4-154,
163