Waste Ink Tray - Epson L800 Service Manual

L800/L801
3. Install the APG Unit to the Main Frame.
Pin
Figure 1-61. Reinstalling the APG Unit (3)
4. Check that the hooks (
holes of the Main Frame, then screw the APG Unit.
Figure 1-62. Reinstalling the APG Unit (4)
Tighten the screws in the order given in
Disassembly/Reassembly
APG Unit
) are attached to the positioning
Main Frame
Fig.1-57 (p.41).

Waste Ink Tray

1.5.5 Waste Ink Tray
Removal procedure
When removing the Waste Ink Tray, take extra care not to spill
C A U T I O N
ink and contaminate the printer and surroundings.
1. Remove the two screws, disengage the hook, and remove the Waste Ink Tray.
Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
Waste Ink Tray
Hook
Figure 1-63. Removing the Waste Ink Tray
Whenever the Waste Ink Tray is replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
Refer to "2.1.2 Required Adjustments" (p.74)
Revision A
42
Confidential