Epson Artison 800 Service Manual page 79

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Troubles during printing and scanning from PC
Table 3-30. Troubles during printing and scanning from PC
Symptom Check Point
Print cannot be made 1. In Wireless LAN's case, check
Scan cannot be made if the network connection
between the PC and Access
Point is made.
2. In Wired LAN's case, check if
the computer and the printer are
properly connected to a LAN
port such as a hub or router.
3. Check the status of network
settings/connection by printing
the network status sheet.
4. Check if the link lamp on the
Access Point or hub connected
to the printer is lighting or
flashing.
5. Check if the network settings
are correctly configured?
6. Check if the network setting
screen is displayed on the
Control Panel.
EPSON Scan cannot 1. For EPSON Scan settings,
be started check if IP address is set
directly.
TROUBLESHOOTING
Remedy
Correctly connect the
computer and the Access
Point.
Correctly connect the
computer and the printer to a
LAN port such as a hub or
router using a LAN cable.
Correctly set the network
connection again if the
network connection is not
made.
• Try using another port.
• Replace the LAN cable.
• Configure Wireless LAN
setting correctly.
Correctly configure the
network settings.
Close the screen.
If IP address is set using the
DHCP function, specify IP
address by searching address.
Network Troubleshooting
http://www.manuals4you.com
Revision C
80
Confidential