Removing The Waste Ink Absorber Tray Assembly - Epson Stylus COLOR 880 Service Manual

EPSON Stylus COLOR 880

4.2.4.2 Removing the Waste Ink Absorber Tray Assembly

1) Remove the Upper Housing. (Refer to Section 4.2.1.)
2) Remove one screw (No.1) securing the Left Housing Panel to the Printer
Mechanism. Refer to Figure 4-9.
3) Remove one screw (No.1) securing Left Sub Frame and remove Left Sub
Frame. Refer to Figure 4-9.
No. 1 Screws
Left Sub Frame
Figure 4-9. Removing the Left Housing Panel &Left Sub Frame
4) Insert a screw driver through the center hole in the Paper Eject Assembly
and remove one screw (No.3) securing the Lower Paper Support Front to
the Waste Ink Absorber Tray Assembly. Remove the Lower Paper Support
Front by releasing three hooks.
Refer to Figure 4-10.
5) Inserting a screw driver through the cutout, remove one screw (No.3)
securing Waste Ink Absorber Tray Assembly to the right bottom part of the
mechanism. Refer to Figure 4-10.
6) On the Left side of the printer mechanism, using tweezers or a small screw
driver, carefully shift the Spacer Tray securing the Waste Ink Absorber
Tray Assembly to left horizontally. Refer to Figure 4-10.
7) Remove the Waste Ink Absorber Tray Assembly pulling it downward.
Disassembly and Assembly
No. 1 Screw
Left Housing Panel
Disassembly Procedures
Paper Eject Assy
Lower Paper Support Front Waste Ink Absorber Tray Assy
Tray Spacer
Figure 4-10. Removing two No.3 screws and Spacer Tray
Revision A
Three hooks
No.3 Screws
89