Pf Timing Belt Tension Adjustment - Epson Artison 800 Service Manual

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W

5.3.3 PF Timing Belt Tension Adjustment

This section describes PF Timing Belt tension adjustment.
Purpose
This adjustment is made when the PF Timing Belt is removed, re-installed, or
loosened. Confirm that the belt tension is proper when the PF Timing Belt is installed.
Things to be used
Tension gauge
Plastic Tweezers
Standard value
7±1N
Adjustment procedure
1. Move the carriage to the home position.
2. Set the following parameters to the tension gauge:
• Weight: 0.9
• Width: 3.0
• Span: 73
3. Bring the microphone closer to the center of the Timing Belt. (See
(p.241))
4. Press the "MEASURE" button on the Tension gauge and flip the Timing Belt with
plastic tweezers.
Bring the microphone within 5mm from the Timing Belt but do not
C H E C K
let it touch the belt.
P O I N T
Flip the belt as weak as the tension gauge can measure it.
C A U T I O N
Be careful not to damage the Timing belt when flipping it with
the plastic tweezers.
Be careful not to let the microphone touch the Timing Belt when
flipping the belt.
ADJUSTMENT
Figure 5-43
5. Repeat the steps three times and make sure all the measured values are within the
standard. If not, turn the Spacer around or over so that another letter (2, 4, or 1 ) comes to
the upper left, and carry out the measurement again. (See
Adjustment without Using Adjustment Program
http://www.manuals4you.com
Figure 5-43. Preparation
" 4.2.4.14 PF Motor " (p.150)
Spacer
Figure 5-44. Spacer
Revision C
)
241
Confidential