Epson Artison 800 Service Manual page 152

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
3. Loosen the screw (x1) that secures the Parallelism Bushing. (See
4. Lift the PG Lever R and disengage the dowel of the Main Frame from the
shaft hole of the Parallelism Bushing. (See
5. Rotate the Parallelism Bushing till the screw that secures the CR Motor Assy
can be seen.
Right side PG Lever R
Dowel &
Parallelism Bushing
shaft hole
C.B.S. 3x6 (Secure it after PG Adjustment)
Figure 4-125. Removing the CR Motor (2)
6. Remove the screws (x4) that secure the CR Motor, and remove the CR Motor
Assy.
Right side
Figure 4-126. Removing the CR Motor (2)
DISASSEMBLY/ASSEMBLY
Fig. 4-125.)
Fig. 4-125.)
Right side PG Lever R
The screw that
secures the CR Motor
Parallelism Bushing
CR Motor Assy
Positioning hole & dowel
C.B.S. 3x6 (8±1Kgfcm)
C.B.S. 3x4 (8±1Kgfcm)
Disassembly Procedures
http://www.manuals4you.com
Be careful not to damage the Pinion Gear of the CR Motor with the
C A U T I O N
CR Motor Holder.
7. Remove the screws (x2) that secure the CR Motor, and remove the CR Motor
from the CR Motor Holder.
CR Motor Holder
Figure 4-127. Removing the CR Motor (3)
Revision C
CR Motor
Groove
C.P. 3x4 (4±1Kgfcm)
153
Confidential