Epson Artison 800 Service Manual page 181

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
4. Remove the screw (x1), and remove the torsion spring and the Grounding
Wire from the ADF Motor Unit, then remove the ADF Motor Unit from the
ADF Frame Unit.
Torsion spring
Grounding Wire
Figure 4-196. Removing the ADF Motor Unit (2)
DISASSEMBLY/ASSEMBLY
ADF Frame Unit
Shafts & holes
ADF Motor Unit
C.B.P. 3x8 (6±1kgfcm)
Disassembly Procedures
http://www.manuals4you.com
Be careful of the following when installing the ADF Motor Unit.
Route the ADF Motor cable, the ADF Sensor cable and the
Grounding Wire as shown below.
ADF Motor Unit
Grounding Wire
Figure 4-197. Routing the cables
Attach the torsion spring from under the ADF EJ Roller.
Figure 4-198. Attaching the torsion spring
Insert the shaft of the ADF Motor Unit to the hole of the ADF
Frame Unit as shown in Fig. 4-196.
Revision C
ADF Motor cable
ADF Sensor cable
Torsion spring
ADF EJ Roller
182
Confidential