Epson Artison 800 Service Manual page 23

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Table 1-17. Combination of the Wired LAN communication mode settings
Setting of this printer
Auto Setting
100BASE-TX Full Duplex
100BASE-TX Half Duplex
10BASE-T Full Duplex
10BASE-T Half Duplex
Wireless LAN
The following interface is equipped for the Wireless LAN connection.
Table 1-18. Wireless LAN
Item
Applied Standard Conforms to IEEE802.11b, IEEE802.11g
(2.4GHz spectrum band
wireless network
standards)
Wireless Operation Mode IEEE802.11b
IEEE802.11g
Communication Range IEEE802.11b (11Mbps)
(line-of-sight distance)*
IEEE802.11g (54Mbps)
Communication Mode Ad-hoc (IBSS) or Infrastructure (ESS)
Roaming Function Not supported
Output Signal Intensity 10mW
Antenna Built-in antenna (Diversity function is not supported)
Note * : Referential value. It depends on surrounding conditions.
PRODUCT DESCRIPTION
Setting of the connected device
Auto Setting (AUTO)
100BASE-TX Half Duplex
10BASE-T Half Duplex
100BASE-TX Full Duplex
Auto Setting (AUTO)
100BASE-TX Half Duplex
10BASE-T Full Duplex
Auto Setting (AUTO)
10BASE-T Half Duplex
Content
DS-SS (Half Duplex)
OFDM (Half Duplex)
• 60m (indoor)
• 220m (outdoor)
• 20m (indoor)
• 100m (outdoor)
http://www.manuals4you.com
Table 1-19. Available Channels and Standard
Frequency Band
Channel
(GHz)
2.400 - 2.4835 1 - 13
2.400 - 2.4835 1 - 13
2.471 - 2.497
Note " * " : The communication speed will be changed automatically, depending on radio wave
strength. bps = bit per second.
Switching Wired/Wireless LAN
This printer can be connect to the network via either Wired LAN or Wireless LAN
connection only.
Enabling/disabling the Wireless LAN can be made from the Control Panel. When the
Wireless LAN is enabled, it gets priority over the Wired Lan regardless of whether the
LAN Cable is connected. The default Wireless LAN setting is "Disabled".
Table 1-20. Wireless LAN Setting from the Control Panel
Setting from Control Panel
Wireless LAN Disabled
(Default)
Enabled
Note* : No service via network is available without connecting the LAN Cable (because
network communication is not established.) except printing a status sheet or the like.
When changing the networks while the power is on, wait at least for
C H E C K
P O I N T 10 seconds between disconnecting and reconnecting.
Interface
Communication Speed
IEEE Standard
802.11b 11/5.5/2/1M
802.11g 54/48/36/24/18/ 12/9/6M
14 802.11/11b 11/ 5.5/2/1M
LAN Cable Connection State
Connected
Wired LAN
Wireless LAN
Revision C
(bps)*
Disconnected
---*
Wireless LAN
24
Confidential