Table of Contents
Advertisement
1.1 Installation Procedure
Follow the steps below to install the DVR:
>
-Place the DVR to proper place following safety precautions on page 2.
>
-Connect cameras to the DVR (see 1.3 if PAN/TILT cameras are used)
>
-Connect the DVR to communication network (see 1.4)
>
-Connect external sensors and controls (see 1.5 and 1.6)
>
-Plug in the watchdog cable
IMPORTANT: unconnected watchdog cable is common mistake when installing
DVR and causes rebooting every 10 minutes that may damage the hard disk in
the DVR
>
-Plug in the power cable
6
Advertisement
Table of Contents
