Table of Contents
Advertisement
1.21 Password Setup
5
4
[Password change]
The Password Setup page allows you to set or change the password for the DVR.
You are prompted for this password whenever you enter 'Setup' or 'Search' modes, or attempt to shut the DVR
software off.
>
This is not the password you use for Remote Access, that password is setup in the 'Modem Setup' page.
>
Level 1 (Administrator)
To set the Level 1 password, you must enter setup as Level 1 (Administrator).
Level 1 user has access to all functions of the DVR as well as the ability to set other user rights and restrictions.
(Level 2 and Level 3 users)
>
Level 2 / Level 3
Level 2 and Level 3 user accounts allow you to assign certain abilities, such as 'Search' or 'Site Information'
access to other users while limiting their access to more sensitive areas, such as 'Hardware Setup' or 'Storage
Setup'
[Old Password]
2
To change the Level 1 password, enter the password you used to enter 'Setup Mode'
If you pressed 'Enter' on the keyboard or clicked on 'OK' to enter Setup with no password, then leave
this box blank.
Level 1 user may also change Level 2 and 3 user passwords without knowing their old password.
3
[New Password]
Enter new password. The password must be 4-
digit numeric. (4-digit,all numbers)
5
[Setup Lists]
Place a check in the box for each function you wish to allow access to for Level 2 and Level 3 users. You
may check as many functions as you wish in any combination. (Note that checking all functions allows
administrator level access.) Level 1 user (Administrator) has access to all functions by default.
1
2
3
4
Password setup tab contains
password settings. There are
3 levels of password protec-
tion. Administrator (level 1)
has full access to the system
and can modify Level 2 and
Level 3 authority.
Password is used to protect
access to Search Mode and
setup Mode only. Surveillance
Mode is not protected by a
password
4
[Confirm]
Re-enter the password to confirm it is typed in
correctly.
38
Advertisement
Table of Contents
