Table of Contents
Advertisement
7
8
9
10
11
13
[Motion for Emergency Message]
7
When selected cameras detect motion, an emer-
gency message will be displayed automatically on
Emergency Monitor window on DN Center PC,
provided Center Software is installed and running.
To specify the IP address of the PC with Center
program installed, enter the IP address on
[Emergency IP address].
8
[Sensor for Emergency]
Select the sensors that will activate the Emer-
gency Message function. When a sensor is
tripped, the DVR will send a message to the
remote, or "Center" computer.
9
[Transfer Time (sec)]
Set the time (in seconds) that the modem will
keep the connection to the remote computer
open and active. Any image captured by selected
cameras during that time will also be transmit-
ted.
10
[Emergency phone numbers]
If you use a modem to connect the DVR to the
remote, or "Center" computer, then
enter the phone numbers of the remote, or
"Center" computer(s) that the DVR will send the
emergency message to. If the DVR fails to con-
nect to the first number, it will dial the second
number and attempt to transmit the message.
12
[Emergency IP Address ]
11
If the DVR is connected to a LAN (Local Area
Network) or to the Internet through a DSL or
Cable Modem connection, you can assign the IP
(Internet Protocol) address of the remote, or
"Center" computer(s) you wish to receive the
Emergency Message.
12
[Anonymous Login]
Check the box to enable anonymous login to
WebDVR via Internet.
Network security should be concerned when
using this function
31
Advertisement
Table of Contents
