With A Lap/Shoulder Belt - Honda CR-V Owner's Manual

10/09/29 19:39:49 42SWAF30_068
Installing a Child Restraint
System with a Lap/Shoulder Belt
When not using the lower
anchorages system, all child
restraint systems must be secured to
the vehicle with the lap part of a lap/
shoulder belt.
In addition, the lap/shoulder belts in
the back seating positions have a
lockable retractor that must be
activated to secure a child restraint
system.
If you intend to install a child
restraint system in the centre
seating position of the rear seat,
make sure the detachable seat belt
anchor is securely latched (see page
194 ).
To properly route a lap/shoulder belt
through a child restraint system,
follow the restraint system maker's
instructions.
For EU countries, refer to page
56 for installing a child restraint
system.
The procedures in the following
pages are described based on a front
facing child restraint system.
1. Place the child restraint system in
the desired back seating position.
Make sure the child restraint is
positioned well back in the seat-
back.
If you place the child restraint
system in any rear seating position
and use the tether strap for
additional security, make sure to set
the head restraint properly and
attach the attaching clip to the
anchor fitting before securing the
child restraint system with the lap/
shoulder belt.
Installing a Child Restraint System
Route the belt through the
2.
restraint according to the restraint
system maker's instructions, then
insert the latch plate into the
buckle and remove any slack from
the lap portion of the belt.
Driver and Passenger Safety
CONTINUED
63