Securing A Child Seat With A Lap/Shoulder Belt - Honda 1996 Odyssey Owner's Manual

Securing a Child Seat with a L a p /
Shoulder Belt
The lap/shoulder belt retractors in
the passenger seating positions have
a built-in locking mechanism
intended to secure a child seat. If
you are placing a child seat in one of
the outside seating positions, do the
following:
1. Place the child restraint in the
desired seating position. Route the
lap/shoulder belt through the seat
according to the seat manufac-
turer's instructions.
2. Insert the latch plate into the
buckle. Make sure it is fully
latched.
3. Slowly pull the shoulder portion of
the belt out of the retractor until it
stops.
4. Allow the belt to slowly feed back
into the retractor. You should hear
a clicking noise that indicates the
locking mechanism has engaged.
5. After the belt has retracted fully,
pull up on the shoulder portion to
remove any slack.
Child Safety
6. Push and pull on the child seat to
verify that it is held firmly in place.
If not, unlatch the seat belt, allow
it to retract fully, and repeat these
steps.
To unlatch the seat belt, push the
red PRESS button on the buckle.
Guide the belt across to the door
pillar. If the belt doesn't retract
easily, pull it out and check for twists
or kinks.
Driver and Passenger Safety