Installing A Child Restraint System With A Lap/Shoulder Belt (With A Lockable Retractor) - Honda legend Owner's Manual

09/01/28 17:39:00 32SMG631_058
Installing a Child Restraint
System with a Lap/Shoulder Belt
(with a Lockable Retractor)
When not using the lower
anchorages system, all child
restraint systems must be secured to
the vehicle with the lap part of a lap/
shoulder belt.
In addition, the lap/shoulder belts in
the back seating positions have a
lockable retractor that must be
activated to secure a child restraint
system.
To check if the lap/shoulder belt is
equipped with the lockable retractor,
pull the lap part of the lap/shoulder
belt all the way out, let the belt
retract slowly, then pull the belt
again gently. If the belt is locked, the
belt is equipped with the lockable
retractor. If it is not, follow the
instruction on page 56
To properly route a lap/shoulder belt
through a child restraint system,
follow the restraint system maker's
instructions.
.
Installing a Child Restraint System
The procedures in the following
pages are described based on a front
facing child restraint system.
1. Place the child restraint system in
the desired back seating position.
Make sure the child restraint is
positioned well back in the seat-
back.
If you place the child restraint
system in either rear outer seating
position and use the tether strap for
additional security, make sure to
push down the head restraint to the
lowest position and attach the
attaching clip to the anchor fitting
before securing the child restraint
system with the lap/shoulder belt.
Driver and Passenger Safety
CONTINUED
53