G3-2/3 Switches - Ricoh D025 Service Manual

Bit Switches

4.3.6 G3-2/3 SWITCHES

These switches require an optional G3 interface unit.
G3-3 switches are the same as for G3-2 switches.
G3-2 Switch 00 [SP No. 1-106-001]
No FUNCTION
Monitor speaker during
communication (tx and rx)
Bit 1: 0, Bit 0: 0 = Disabled
0-1 Bit 1: 0, Bit 0: 1 = Up to Phase
B
Bit 1: 1, Bit 0: 0 = All the time
Bit 1: 1, Bit 0: 1 = Not used
Monitor speaker during
2 memory transmission
0: Disabled 1: Enabled
3-6 Not used
G3-2 Switch 01 [SP No. 1-106-002]
No FUNCTION
0-3 Not used
DIS frame length
4
0: 10 bytes, 1: 4 bytes
5 Not used
CED/ANSam transmission
6 0: Disabled
1: Enabled
D393
COMMENTS
(0, 0): The monitor speaker is disabled all through
the communication.
(0, 1): The monitor speaker is on up to phase B in
the T.30 protocol.
(1, 0): Used for testing. The monitor speaker is on
all through the communication. Make sure that you
reset these bits after testing.
1: The monitor speaker is enabled during memory
transmission.
Do not change the settings.
COMMENTS
Do not change the settings.
1: The bytes in the DIS frame after the 4th byte will
not be transmitted (set to 1 if there are
communication problems with PC-based faxes
which cannot receive the extended DIS frames).
Do not change the setting.
Do not change this setting, unless the
communication problem is caused by the
CED/ANSam transmission.
114 SM