Error Codes
Code
Meaning
Modem training fails even
0-05
G3 shifts down to 2400
bps.
The other terminal did not
0-06
reply to DCS
No post-message
0-07
response from the other
end after a page was sent
The other end sent RTN or
PIN after receiving a page,
0-08
because there were too
many errors
D393
Suggested Cause/Action
Cable equalizer - G3 Switch 07 (PSTN)
Dedicated Tx parameters in Service Program
Mode
Check the line connection.
Try adjusting the tx level and/or cable
equalizer.
Replace the FCU.
Check for line problems.
Cross reference
See error code 0-04.
Check the line connection.
Try adjusting the tx level and/or cable
equalizer settings.
Replace the FCU.
The other end may be defective or
incompatible; try sending to another machine.
Check for line problems.
Cross reference
See error code 0-04.
Check the line connection.
Replace the FCU.
The other end may have jammed or run out of
paper.
The other end user may have disconnected
the call.
Check for a bad line.
The other end may be defective; try sending to
another machine.
Check the line connection.
Replace the FCU.
The other end may have jammed, or run out of
paper or memory space.
24
SM