Ricoh D025 Service Manual page 1414

1-3 Not used
Dialing on the ten-key pad
when the external telephone is
4
off-hook
0: Disabled 1: Enabled
On hook dial
5
0: Disabled 1: Enabled
6-7 Not used
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E [SP No. 1-101-015]
No FUNCTION
0-1 Not used
Enable/disable for direct
sending selection
2
0: Direct sending off
1: Direct sending on
Action when the external
handset goes off-hook
0: Manual tx and rx operation
3
1: Memory tx and rx operation
(the display remains the
same)
SM
Do not change these settings.
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting
when the external telephone is not by the
machine, or if a wireless telephone is connected
as an external telephone.
1: The user can dial on the machine's ten-key pad
when the handset is off-hook.
0: On hook dial is disabled.
Do not change the factory settings
COMMENTS
Do not change the settings.
Direct sending cannot operate when the capture
function is on during sending. Setting this switch to
"1" enables direct sending without capture. Setting
this switch to "0" masks the direct sending function
on the operation panel so it cannot be selected.
0: Manual tx and rx are possible while the external
handset is off-hook. However, memory tx is not
possible.
1: The display stays in standby mode even when
the external handset is used, so that other people
can use the machine for memory tx operation.
73
Bit Switches
D393