Ricoh D025 Service Manual page 1457

Bit Switches
0: Disabled
1: Enabled
ECM frame size
3 0: 256 bytes
1: 64 bytes
CTC transmission conditions
0: After one PPR signal
4 received
1: After four PPR signals
received (ITU-T standard)
Modem rate used for the next
page after receiving a negative
5
code (RTN or PIN)
0: No change, 1: Fallback
6 Not used
7
Not used
G3-2 Switch 04 [SP No. 1-106-005]
No FUNCTION
D393
Do not set to 0 unless the line condition is
always bad enough to slow down the data
rate to 14.4 kbps or lower.
Keep this bit at "0" in most cases.
0: When using ECM in non-standard (NSF/NSS)
mode, the machine sends a CTC to drop back the
modem rate after receiving a PPR, if the following
condition is met in communications at 14.4, 12.0,
9.6, and 7.2 kbps.
NTransmit- Number of transmitted frames
NResend- Number of frames to be retransmitted
1: When using ECM, the machine sends a CTC to
drop back the modem rate after receiving four
PPRs.
PPR, CTC: These are ECM protocol signals.
This bit is not effective in V.34 communications.
1: The machine's tx modem rate will fall back
before sending the next page if a negative code is
received. This bit is ignored if ECM is being used.
Do not change the settings.
Do not change the settings.
COMMENTS
116 SM