Summary Of Electrical Components - Ricoh D025 Service Manual

Electrical Components

2.7.2 SUMMARY OF ELECTRICAL COMPONENTS

Motors
M1 Feed-Out Belt Motor
M2 Front Fence Motor
Positioning Roller Arm
M3
Motor
M4 Rear Fence Motor
Stapler Movement
M5
Motor
M6 Transport Motor
M7 Tray Lift Motor
M8 Stapler Motor
Board
PCB1 Main Board
Sensors
S1 Entrance Sensor
Feed Out Belt HP
S
Sensor
D372
Drives the two feed-out belts (1 pawl each). The
pawls push the finished stack out of the finisher.
Moves the front fence to the back and front.
Lowers and raises the positioning roller arm and
positioning roller.
Moves the rear fence to the front and back.
Moves the stapler to the front and back.
Drives all the rollers in the finisher: entrance
roller, positioning roller, return rollers, exit roller
Raises and lowers the output tray.
The motor inside the stapler that drives staple
supply and stapling.
Controls operation of the finisher. DIP switches
can be changed to adjust the positions of the
front and rear side fences.
Detects the leading edge of the paper when it
enters the finisher. Readings of this sensor are
used for timing of finisher operation. Also detects
jams.
Detects the HP of the feed-out belt pawls on the
two feed-out belts (one pawl on each belt).
52 SM