Assemble I/O Expansion Racks; Table 11 - Assemble I/O Expansion Racks - Honeywell HC900 Installation And User Manual

Rack Installation - Assemble I/O Expansion Racks

Assemble I/O Expansion Racks

I/O Expansion Rack assembly information is given in Table 11.
Step
Insert power supply into
1
left-most slot in the I/O
rack. See Table 9 steps 1
and 2 for wiring details.
Redundant Power
2
(optional):
Insert the second power
supply in the left side of
the smaller compartment,
see 1 in figure above. See
Table 10 steps 1 and 2 for
details.
Insert the PSM between
the 2 power supplies.
Fasten it in place with
screws at top and bottom.
64
Table 11 – Assemble I/O Expansion Racks
Procedure
If using redundant power, your I/O rack will contain a second
smaller compartment, see 1 in the following figure. Insert first
power supply in the larger compartment as shown, to the
immediate right of the plate dividing the two compartments.
See 1 in figure above. See Table 9 steps 1 and 2 for details.
HC900 Process Controller Installation and User Guide
Comments/References
Revision 19
06/14