Board Layout; About Expansion Options; About Option Cards - Honeywell WEB-600E Manual

Removing and Replacing the Cover
You must remove the controller's cover to install any option cards, or to install (or replace) the optional NiMH backup battery. The
cover snaps onto the base with four plastic end tabs—two on each end.
NOTE: If accessory modules are plugged into the con-
troller, you may need to slide them away from the
unit to get to the end cover tabs.

Board Layout

Figure 3 shows the location of LEDs, option slots, and other features of the WEB-600E controller with cover removed. For a side
view of communications ports and other features, see Fig. 6.
BRACKET FOR
OPTIONAL
NIMH BACKUP
BATTERY
OPTION SLOT
CONNECTORS
The controller ships with onboard static RAM (SRAM) that can provide station backup during power loss, and also has two (2)
open option card slots for a variety of available option cards. For details, see "About Expansion Options" on page 5 below, and
also "About Backup Configurations" on page 13.

ABOUT EXPANSION OPTIONS

The controller provides for field-installable expansion using
these types of options:
• Option cards — Install on connectors on the controller's
base board. See "About Option Cards" on page 5.
• Accessory modules — To "chain" on the controller's 20-pin
connector. See "About Accessory Modules" on page 7.
COVER
Fig. 2. Press in four tabs on end to remove cover.
SERIAL PORT LEDS ON BOTTOM BOARD, REMOVE COVER TO SEE:
OPTION
SLOT 2
COM 1
OPTION SLOT 1
SECONDARY
ETHERNET
(RJ-45) LAN2
(TOP BOARD)
Fig. 3. WEB-600E controller main board layout details.
WEB-600E AND CP-600E NETWORK CONTROLLERS
COVER TABS
(2 EACH END)
PRESS
TABS IN
• To remove the cover, press in the tabs on both ends of the
unit, and carefully lift it off.
• To replace the cover, orient it so the cutout area for comm
ports is correct, then push inwards to snap in place.
STATUS LEDS (VISIBLE WITH COVER ON):
LAN1
COM 2 LAN2 BEAT STATUS
(PRI)
(SEC)
NPM6E PROCESSOR
MODULE WITH
INTEGRAL SRAM
RS-232
RS-485
PRIMARY
(DB-9)
(3-POS.)
ETHERNET
COM1
COM2
(RJ-45) LAN1
(BOTTOM
(BOTTOM
(TOP BOARD)
BOARD)
BOARD)

About Option Cards

The WEB-600E has two (2) available option slots for option
cards designed for use with WEB controllers. Each slot has a
30-pin connector. Installing an option card is recommended
before mounting the unit. See "Installing an Option Card" on
page 7.
5
COVER
LIFTED
AWAY
M33915
MODE JUMPER
(FOR SERIAL
SHELL ACCESS)
NORMAL
SERIAL SHELL
20-PIN
CONNECTOR
(I/O AND
POWER
MODULES)
EARTH GROUND
SPADE LUG
BARREL POWER
CONNECTOR FOR
WALL MOUNTED
POWER MODULE
(NPB-WPM-US)
M33918
62-0433—01