Appendix - Installation of Remote Termination Panels (RTPs) - Analog Input/Digital Input/Digital Output/Analog
Output
Analog Input/Digital Input/Digital Output/Analog Output
A single DI/DO/AO-RTP and cable is used with the following modules:
•
4-point Analog Output
•
16-point Contact Digital Input
•
16-point DC Digital Input
•
16-point AC Digital Input
•
16-point DC Digital Output
•
8-point AC Digital Output
•
8-point Analog Output
Dual DI/DO/AO-RTPs and cables are used with the following modules:
•
16-point Analog Output
•
16-point Analog Input
•
32-Point DC Digital Output
•
32-Point DC Digital Input
4 Point Analog Output
Step
1
ATTENTION: RTP and cables are intended for permanent installation within their own enclosure.
Mount RTP cable assembly to HC900 Controller (Figure 92).
•
Remove appropriate key tabs from terminal block to allow mating with the module. See page 75.
•
Connect desired cable to AO module at controller. Choose from:
900RTC-L010
900RTC-L025
900RTC-L050
•
Install AO module label onto the module connector cover.
•
Connect shield drain wire to the grounding bars at the base of the HC900 rack. All field-wiring
shields must be grounded as described in the shield grounding section (page 70).
2
Mount RTP to DIN rail.
•
Latch to rail. See page 244.
•
Connect cable to RTP
Revision 19
06/14
Remote Terminal Low Voltage Cable Assembly, 1.0 meters long
Remote Terminal Low Voltage Cable Assembly, 2.5 meters long
Remote Terminal Low Voltage Cable Assembly, 5.0 meters long
HC900 Process Controller Installation and User Guide
See page
See page
Action
219
221
222
224
225
228
231
234
235
238
240
219