Product Description; Onboard Security I/O; Expansion Modules - Honeywell SEC-H-600 Installation Instructions Manual

SEC-H-600 SECURITY CONTROLLER

PRODUCT DESCRIPTION

The Security Controller (model SEC-H-600) is an expandable, DIN rail-mountable, controller that provides an embedded access
control and security alarm monitoring system. The controller hosts the WEBs-AX Security Application, allowing password-
authorized users to access the system using a standard web browser. Once authenticated, a user can configure and administer
the system. Apart from providing access control, features include graphical real-time display of data, calendar and scheduling
functions, historical data logging, alarm monitoring, and event handling. For more details on features, see the data sheet for the
SEC-H-600.
One or two rechargeable, sealed-lead-acid backup batteries allow system operation upon loss of primary power, for some
duration. In addition, the Security Controller has a standard on-board NiMH battery to ensure its configuration is always retained.
See "About the Backup Batteries" on page 27 for more information.
See the following sections for more details:
• "Onboard Security I/O" on page 2
• "Expansion Modules" on page 2
• "Option Cards" on page 3
• "WEBs-AX Security Enclosure" on page 4

Onboard Security I/O

The SEC-H-600 model of Security Controller provides standard onboard security I/O points, as follows:
• 2 card reader inputs (7-pin connectors, each can power a 12V Wiegand-type reader)
• 6 supervised inputs (4 allocated for usage with readers, 2 are general usage)
• 4 Form-C relay outputs (2 allocated for usage with readers, 2 are general usage)
• 3 digital inputs (unsupervised, for predefined system monitoring)
Additional security I/O points are achieved by adding expansion modules. A fully expanded SEC-H-600 can support a total of 32
readers (using 15 SEC-H-R2R expansion modules). Or, other combinations are possible with fewer readers but more general
usage I/O using SEC-H-RIO expansion modules. See "Expansion Modules" below.

Expansion Modules

Table 1 lists the currently available Security Controller expansion modules. Note that the SEC-H-600 Security Controller supports
a maximum of 15 expansion modules, in any combination of SEC-H-R2R and SEC-H-RIO needed. This varies from the SEC-H-
201 controller, which also supports up to 15 expansion modules—however, only 7 of them can be SEC-H-R2R modules (others
must be SEC-H-RIO modules).
Model
SEC-H-R2R Remote 2 Reader Module
DIN-mountable module that expands
the door reader capacity by 2, with
associated digital inputs and outputs.
SEC-H-RIO Remote I/O Module
DIN-mountable module that expands
capacity with 8 supervised inputs and
8 relay outputs.
95-7759—07
Table 1. Security Controller (SEC-H-600) type expansion modules.
Description
Each SEC-H-R2R provides the following security points:
• 2 - Reader ports (each 7-pin, to power a 12V Wiegand-type reader)
• 4 - Supervised inputs (2 per reader).
• 2 - Form-C relay outputs (1 per reader).
• 2 - Digital inputs for cabinet tamper and low battery detection.
Up to 15 (maximum) SEC-H-R2R modules are supported by an SEC-H-600.
Each SEC-H-RIO provides the following security points:
• 8 - Supervised four-state inputs (open, closed, short, and cut).
• 8 - Form-C relay outputs.
• 2 - Digital inputs for cabinet tamper and low battery detection.
Notes
2