The LU-860 Lightning
Sensor
Controller
is used
to select the modes of
operation of the lightning sensor system. The switch functions are
listed in Table 12-3.
OFF
All power removed.
STBY
Display is inhibited but the processor is
accumulating data.
LX
System is fully operational. All accumulated
lightning data is displayed.
CLR/TEST
Accumulated data is cleared from memory. After
3 seconds the test mode is initiated.
LU-860 Switch Functions
Table 12-3
22-14-00
Page 198:177
Apr 15/93
Use or disclosure of information on thispage issubject to the restrictions o n the title page of this document.