Tires And Wheels; Tire & Wheel Inspection; Tire Pressure; Spark Plug - E-TON Viper 70 Owner's Manual

Tires and Wheels

Tire & Wheel Inspection
It is important to inspect your tires and wheels
for damage and wear before each riding
session. Inspect each tire for cuts, tears and
punctures. Inspect the wheel rim for dents
and separation of the wheel from the tire bead.
Replace any tire or wheel found to be
damaged.
Operating your ATV with damaged tires or
wheels is dangerous. Damaged tires or
wheels can result in a sudden loss of tire
pressure and control which could result in
injuries.
Check your tire pressure before each riding
session and at each refueling operation.
Always check the pressure when the tires are
cool. Use the tire pressure gauge that came
with your ATV to check the tire pressure.

Tire Pressure

Recommended tire pressure is:
Min 3.2psi / 0.23kg/cm
Front
Max 4.0psi / 0.28kg/cm
Min 3.2psi / 0.23kg/cm
Rear
Max 4.0psi / 0.28kg/cm
Wheel Nut torque 24-30 N/m (18-22 lb/ft)

Spark Plug

Replace spark plug at the beginning of each
season with a replacement plug number
NGK – CR7HSA
1. Disconnect spark plug wire.
Copyright ©2008-2009 ETON America, all rights reserved.
.

Exhaust System Maintenance

Muffler Cleaning

Page 15
2. Clean dirt from around spark plug base
with brush or air.
3. Remove spark plug with spark plug
wrench.
4. Set the spark plug gap on the new plug
to 0.023"
5. Install the new plug screwing it in finger
tight and then use the plug wrench to
screw the plug in another ½ turn.
6.
Inspect the spark plug wire for cuts, nicks
or other damage. Replace as needed.
1. After every 50 hours of operation the
muffler should be cleaned by removing
the clean out bolt by using a 12mm
wrench.
2. Tilt the ATV from the front and allow any
accumulated condensation to drain from
the muffler.