Engine Stop Switch; Throttle Lever; Front & Rear Brakes - E-TON CXL-150 Owner's Manual

Engine Stop Switch

The stop switch is a red colored rocker switch
located on the left-hand handle bar.
To start and run the engine, this switch must
be placed in the on, "O", position.
The vehicle is also equipped with a safety
brake switch which will prevent the engine
from starting until the parking brake is engaged.
To stop your engine, place the switch to the
stop, "X", position.
In the stop, "X", position the ignition system is
grounded preventing the spark plug from firing.
This switch can also be used as a safety or
emergency stop switch.

Throttle lever

The throttle lever is located on the right-hand
handle bar below the grip. To operate the
throttle lever, place your right thumb on the
lever and press forward to increase your speed.
To decrease your speed, reduce your pressure
on the lever and the spring tension will
automatically reduce your speed.
The travel of the throttle lever is controlled by
the throttle stop bolt.
Copyright ©2008-2009 ETON America, all rights reserved.
Control Features
Page 8
As your operator gains more experience, you
can increase the throttle travel to allow for
additional speed to be obtained.
To increase the throttle's travel, thus
increasing the maximum speed, turn the
throttle stop bolt counter clockwise. To
decrease the throttle's travel, thus decreasing
the maximum speed, turn the throttle stop bolt
clockwise.
The throttle cable should be adjusted so there
is 2mm, (1/8") free travel at the lever before
the throttle starts to open.
Front and Rear Brakes
This vehicle is equipped with dual front
mechanical drum brakes and a rear hydraulic
disc brake.
The front brakes are controlled by the long
brake lever on the right-handle bar.
The rear brake is controlled by the long lever
on the left-handle bar.