Checking The Rear Wheel Hubs; Installing The Wheel Hubs - E-TON ATV6A 90 Service Manual

FRONT AND REAR WHEELS
WARNING
Eye protection is recommended when
using striking tools.
c. To install the wheel bearings, reverse the
above sequence. Use a socket that
matches outside diameter of bearing outer
race to drive in bearing.
N O T I C E
Do not strike the center race or balls of the
bearing. Contact should be made only with
the outer race.

CHECKING THE REAR WHEEL HUBS

The following procedure applies to both of the
rear wheel hubs.
1. Check:
• rear wheel hub
Cracks/damage
• wheel hub splines
Wear/damage

INSTALLING THE WHEEL HUBS

The following procedure applies to both of the
front and rear wheel hubs.
1. Install:
• axle nut
Front wheel hub:
Rear wheel hub:
• cotter pin
TIP
Do not loosen the axle nut after torquing it. If
the axle nut groove is not aligned with the cot-
ter pin hole, align the groove with the hole by
tightening the axle nut.
6 - 4
CHAS
Replace.
Replace.
65 Nm (6.5 m kg, 47.0 ft
•
135 Nm (13.5 m kg, 97.6 ft lb)
•
New
Ib)
•
•