Hearing Aid Compatibility; Industry Canada Cs-03 - NEC UNIVERGE NEAX 2000 IPS General Description Manual

REGULATORY INFORMATION

Hearing Aid Compatibility

The Dterm terminals provided for the UNIVERGE
compatible. FCC rules prohibit the use of non-hearing aid compatible telephones.
NEC-type single-line telephone sets used in conjunction with the UNIVERGE
IPS are hearing aid compatible. If other than NEC-type single-line telephone sets are to
be used with this system, ensure that these are hearing aid compatible.

Industry Canada CS-03

Certification number: 140 5976 A
Load Number of the equipment: 1.0
NOTICE: The Industry Canada label identifies certified equipment. The certification
means that the equipment meets certain telecommunications network protective
operational and safety requirements. The department does not guarantee the equipment
will operate to the user's satisfaction.
Before installing the equipment, users should ensure that it is permissible to be connected
to the facilities of the local telecommunications company. The equipment must also be
installed using an acceptable method of connection. In some cases, the company's inside
wiring associated with a single line individual service may be extended by means of a
certified connector assembly (telephone extension cord). The customer should be aware
that compliance with the above conditions might not prevent degradation of service in
some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance
facility designated by the supplier. Any repairs or installations made by the user to this
equipment, or equipment malfunctions, may give the telecommunications company
cause to request that the user disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the
power utility, telephone lines, and internal metallic water pipe system, if present, are
connected together. This protection may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority, or electrician, as
appropriate.
NOTICE: The Load Number assigned to each terminal device denotes the percentage of
the total load to be connected to a telephone loop which is used by the device, to prevent
overloading. The termination on a loop may consist of any combination of devices
subject only to the requirement that the total of the load numbers of all the devices does
not exceed 100.
UNIVERGE NEAX 2000 IPS General Description
Issue 5
2000 IPS are hearing aid
NEAX
NEAX
2000
Page 6