Chapter 5 Feature Description; Business/Hotel Motel Features - NEC UNIVERGE NEAX 2000 IPS General Description Manual

Chapter 5 Feature Description

Business/Hotel Motel Features

Account Code
This feature, when used with Station Message Detail Recording (SMDR), allows station users
and Attendants to enter a cost accounting or client billing code (up to 16 digits) into the system.
Add-On Module
This feature allows the Add-On Module to be combined with a Multiline Terminal when there
are insufficient line or trunk keys provided at the Multiline Terminal. When the Add-On Module
unit keys are programmed as line/trunk keys, the additional 25 lines/trunks and the existing
lines/trunks set for the Multiline Terminal can be accessed directly (maximum of 49
lines/trunks). The station speed dialing function can be assigned for all keys on the Add-On
Module unit. Also, one of the last 3 keys can be used as a Day/ Night change key.
Alarm Indications
Faults are indicated by the Major/Minor (MJ/MN) lamps located on the AC/DC Power Supply
and, optionally, an external alarm display unit. Station Application not applicable.
Alphanumeric Display
The LCD on Multiline Terminals is used to provide alphanumeric information including
clock/calendar and call processing information. Station Application All Multiline Terminals
with an LCD display.
Analog Port Adapter
This feature allows an Analog Port Adapter unit combined with a legacy Multiline Terminal to
connect to an analog terminal such as an analog telephone, Modem, and PC with built-in
Modem. There are two communication modes for the terminal connected via the Analog Port
Adapter as shown below:
1. Single Port Mode
A Multiline Terminal and an analog terminal share the same port. In this mode, the Multiline
Terminal and the analog terminal cannot be used simultaneously.
2. Dual Port Mode
A Multiline Terminal and an analog terminal use different ports. In this mode, the Multiline
Terminal and the analog terminal can be used simultaneously.
Announcement Service
This feature allows station users to record messages on Digital Announcement Trunk (DAT)
cards. When a station user dials the feature access code for this feature, the user receives the
corresponding message from the system. Also Announcement Service can be used to provide a
voice message in the following cases;
• An incoming C.O. line/Tie line call has been transferred and encounters a busy or no
answer condition
• An incoming DID line/Tie line call has been terminated to a station and encounters a busy
or no answer condition
• Internal Recorded Message in place of Music on Hold
• Night Announcement
UNIVERGE NEAX 2000 IPS General Description
Issue 5
CHAPTER 5 FEATURE DESCRIPTION
Page 101