Ips Ips; Dml; C Onfiguration - NEC UNIVERGE NEAX 2000 IPS General Description Manual

CHAPTER 2 SYSTEM CONFIGURATION

DML

UNIVERGE IPS System Configuration
®
NEAX
DML
The UNIVERGE IPS consists of from one to eight MODULAR CHASSIS depending
NEAX
on the system configuration. There are 2 types of MODULAR CHASSIS; "Physical Modular
Chassis" and "Virtual Modular Chassis ".
The Physical Modular Chassis is "hardware Modular Chassis" and is used to accommodate an
MP, FPs, IP PADs, legacy LT/AP cards, and power supply units. The Physical Modular Chassis
provides 56 LT ports in hardware slots and provides 8 ports in software port allocation (56 LT
ports and 8 virtual ports). One Modular Chassis provides 8 card slots including one card slot for
Main Processor (MP) and other 7 slots for Line Trunk (LT)/Application Processor (AP) cards; 56
LT ports and 8 virtual LT ports; AC, LTC, BUS cable connectors and power switch which are
located at the rear side of Modular Chassis. The Physical Modular Chassis can be installed on
the desktop or into the 19-inch rack only.
The Virtual Modular Chassis is a "software Modular Chassis" with a port capacity of 64 ports.
The Virtual MC is a "software" MC and is used to accommodate IP telephones by system data
programming. The port capacity of the Virtual MC is different depends on the number of
Physical MC.
The port allocation varies with the version of system.
Software Port Allocation for Each Physical MC Configuration
UNIVERGE NEAX 2000 IPS General Description Page 38
Issue 5