Removal And Installation; Door Module - Jeep 1996 Grand Cherokee Service Manual

ZJ

REMOVAL AND INSTALLATION

DOOR MODULE

(1) Disconnect and isolate the battery negative
cable.
(2) Remove the bezel near the inside door latch
release handle by inserting a straight-bladed screw-
driver in the notched end and prying gently upwards.
(3) Remove the door trim panel mounting screw
located in the bezel opening near the inside door
latch release handle (Fig. 2).
Fig. 2 Front Door Trim Panel Remove/Install
(4) Remove the trim cap and screw near the rear
of the door armrest.
(5) Remove the trim cap and screw at the upper
front corner of the trim panel.
(6) Remove the screw located above the front door
speaker grille.
(7) Using a wide flat-bladed tool such as a trim
stick, pry the trim panel away from the door around
the perimeter and remove the trim panel.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
(8) Unplug the wiring connectors from the door
module and the door courtesy lamp, if equipped.
(9) Remove the five screws securing the door mod-
ule to the door trim panel (Fig. 3).
(10) Remove the door module from the trim panel.
(11) Reverse the removal procedures to install.
POWER WINDOW SWITCH
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the rear door trim panel bezel near the
inside door latch release handle by inserting a
straight-bladed screwdriver in the notched end and
prying gently upwards.
POWER WINDOW SYSTEMS
Fig. 3 Door Module Remove/Install
(3) Remove the door trim panel mounting screw
located in the bezel opening near the inside door
latch release handle (Fig. 4).
Fig. 4 Rear Door Trim Panel Remove/Install
(4) Remove the trim cap and screw near the rear
of the door armrest.
(5) Using a wide flat-bladed tool such as a trim
stick, pry the trim panel away from the door around
the perimeter and remove the trim panel.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
8S - 5