Jeep 1996 Grand Cherokee Service Manual page 374

ZJ
REMOVAL AND INSTALLATION (Continued)
Fig. 14 Multi-Function Switch Connector
• Multi-function switch connector screw - 1.9 N·m
(17 in. lbs.)
• Multi-function switch retaining screws - 1.9 N·m
(17 in. lbs.)
• Steering column upper bracket nuts - 12 N·m
(110 in. lbs.).
REAR
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Using a trim stick or other suitable wide flat-
bladed tool, pry gently around the edges of the right
switch pod bezel and remove the bezel.
(3) Remove the three screws securing the right
switch pod to the instrument panel (Fig. 15).
(4) Pull the right switch pod out from the instru-
ment panel far enough to unplug the wiring connec-
tors.
(5) Remove the right switch pod from the instru-
ment panel.
(6) Reverse the removal procedures to install.
GROUP 8M - PASSIVE
BEFORE ATTEMPTING
STEERING COLUMN,
WIPER AND WASHER SYSTEMS
Fig. 15 Right Switch Pod Remove/Install
WASHER PUMPS AND RESERVOIR
(1) Disconnect and isolate the battery negative
cable.
(2) Disconnect the wiring from the fluid level sen-
sor, if equipped.
(3) Remove the three screws securing the washer
reservoir (Fig. 16).
OR
Fig. 16 Washer Reservoir Remove/Install
(4) Disconnect the hoses from the washer pumps,
and drain the solvent from the reservoir into a clean
container for reuse.
(5) Use a deep socket and extension, inserted
through the reservoir filler neck, to remove the
washer pump filter/nuts from inside of the reservoir.
(6) Remove the pumps from the reservoir.
(7) Reverse the removal procedures to install.
8K - 13