Jeep 1996 Grand Cherokee Service Manual page 401

8M - 6 PASSIVE RESTRAINT SYSTEMS
REMOVAL AND INSTALLATION (Continued)
Fig. 6 Horn Switch Wires Remove/Install
(5) Remove the four nuts securing the upper and
lower trim cover retainers to the studs on the airbag
housing (Fig. 7).
Fig. 7 Trim Cover Retainers Remove/Install
(6) Remove the upper and lower trim cover retain-
ers from the airbag housing studs.
(7) Release the five trim cover locking blocks from
the lip around the outside edge of the airbag housing
and remove the housing from the cover (Fig. 8).
Fig. 8 Trim Cover Remove/Install
(8) When installing the trim cover/horn switch, be
certain that the locking blocks are fully engaged on
the lip of the airbag housing (Fig. 9).
Fig. 9 Trim Cover Locking Blocks Install
(9) When installing the upper and lower trim cover
retainers, be certain that the tabs on each retainer
are engaged in the retainer slots of the trim cover
(Fig. 8). Tighten the retainer nuts to 10 N·m (90 in.
lbs.).
(10) Reverse the remaining removal procedures to
complete the installation, but do not connect the bat-
ZJ