Jeep 1996 Grand Cherokee Service Manual page 388

ZJ
REMOVAL AND INSTALLATION
CARGO LAMP . . . . . . . . . . . . . . . . . . . . . . . . . . 16
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
DOME/READING LAMP . . . . . . . . . . . . . . . . . . . 15
DOOR COURTESY LAMP . . . . . . . . . . . . . . . . . 16
FOG LAMP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
HEADLAMP . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
REMOVAL AND INSTALLATION
HEADLAMP
REMOVAL
(1) Grasp lower edge of headlamp lens and pull
straight back (away) from grille opening reinforce-
ment (GOR). Disengage lower adjuster pivots from
lens assembly.
(2) Grasp upper edge of headlamp lens. Pull
straight back (away) from grille opening reinforce-
ment (GOR). Disengage upper adjuster pivot from
lens assembly.
(3) Rotate bulb lock ring counterclockwise. and
remove ring and bulb from lens.
INSTALLATION
(1) Replace by seating the assembly in the lamp
housing and turning the lock ring 1/8 turn clockwise
to secure.
(2) Align upper adjust pivot into headlamp open-
ing and snap into place.
(3) Snap lower adjuster pivots into place.
FOG LAMP
REMOVAL
(1) Remove adjustment screw (Fig. 1).
(2) Disengage fog lamp electrical connector.
(3) Separate fog lamp from vehicle.
INSTALLATION
(1) Position fog lamp at vehicle.
(2) Engage fog lamp electrical connector.
(3) Install adjustment screw (Fig. 1).
LAMP SERVICE
INDEX
page
LICENSE PLATE LAMP . . . . . . . . . . . . . . . . . . . 14
PARKING LAMP . . . . . . . . . . . . . . . . . . . . . . . . . 13
TAIL, STOP, TURN SIGNAL, BACK-UP AND
SIDE MARKER LAMP . . . . . . . . . . . . . . . . . . . 14
TURN SIGNAL AND SIDE MARKER LAMP . . . . . 14
UNDERHOOD LAMP . . . . . . . . . . . . . . . . . . . . . 15
VISOR VANITY LAMP . . . . . . . . . . . . . . . . . . . . . 15
(4) Align fog lamp.
PARKING LAMP
REMOVAL
The parking lamp is mounted on the side of the
GOR next to headlamp assembly.
(1) Open hood.
(2) Remove screws which hold the parking lamp in
position (Fig. 2).
(3) Rotate lamp socket counterclockwise and pull
socket from lamp.
INSTALLATION
(1) Position lamp socket in lamp and rotate clock-
wise.
(2) Position lamp in place and install the screws.
LAMPS
Fig. 1 Fog Lamp
8L - 13
page