Power Mirror - Jeep 1996 Grand Cherokee Service Manual

8T - 4 POWER MIRROR SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(4) Remove the trim cap and screw near the rear
of the door armrest.
(5) Remove the trim cap and screw at the upper
front corner of the trim panel.
(6) Remove the screw located above the front door
speaker grille.
(7) Using a wide flat-bladed tool such as a trim
stick, pry the trim panel away from the door around
the perimeter and remove the trim panel.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
(8) Unplug the wiring connectors from the door
module and the door courtesy lamp, if equipped.
(9) Remove the five screws securing the door mod-
ule to the door trim panel (Fig. 3).
(10) Remove the door module from the trim panel.
(11) Reverse the removal procedures to install.

POWER MIRROR

(1) Disconnect and isolate the battery negative
cable.
(2) Remove the door trim panel as described under
Door Module in this group.
(3) Unplug the electric chromatic mirror connector,
if equipped.
(4) Unclip the mirror harnesses from the inner
door panel.
(5) Remove the mirror flag seal (Fig. 4).
(6) Remove the three nuts securing the mirror to
the door.
Fig. 3 Door Module Remove/Install
(7) Remove the mirror from the door.
(8) Reverse the removal procedures to install.
Tighten the mirror nuts to 7.4 N·m (65 in. lbs.).
Fig. 4 Power Mirror Remove/Install
ZJ