Set Lamp - Jeep 1996 Grand Cherokee Service Manual

8Q - 8 VEHICLE THEFT/SECURITY SYSTEMS
REMOVAL AND INSTALLATION (Continued)

SET LAMP

WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Using a wide flat-bladed tool such as a trim
stick, pry the cowl top trim panel off of the instru-
ment panel top pad (Fig. 14).
(3) Pull the panel up far enough to unplug the wir-
ing connector for the solar sensor, or to remove the
solar sensor from the cowl top trim between the right
and center defroster outlets, if so equipped.
(4) Remove the cowl top trim panel from the vehi-
cle.
(5) Remove the auto headlamp light sensor/vehicle
theft security system set lamp mounting screw near
the left defroster duct outlet.
GROUP 8M - PASSIVE
BEFORE ATTEMPTING
STEERING COLUMN, OR
Fig. 14 Cowl Top Trim Remove/Install
(6) Pull the lamp up far enough to unplug the wire
harness connector and remove the lamp.
(7) Reverse the removal procedures to install.
ZJ