Jeep 1996 Grand Cherokee Service Manual page 321

8E - 24 INSTRUMENT PANEL SYSTEMS
REMOVAL AND INSTALLATION (Continued)
Fig. 9 Left Switch Pod Remove/Install
RIGHT SWITCH POD
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the right switch pod bezel as described
in this group.
(3) Remove the three screws securing the right
switch pod to the instrument panel (Fig. 10).
Fig. 8 Cluster Bulb Locations
GROUP 8M - PASSIVE
BEFORE ATTEMPTING
STEERING COLUMN,
Fig. 10 Right Switch Pod Remove/Install
(4) Pull the right switch pod out from the instru-
ment panel far enough to unplug the wiring connec-
tors.
(5) Remove the right switch pod from the instru-
ment panel.
OR
(6) Reverse the removal procedures to install.
BODY CONTROL MODULE
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
TO GROUP 8M -
BEFORE ATTEMPTING
STEERING COLUMN,
ZJ
PASSIVE
OR