Jeep 1996 Grand Cherokee Service Manual page 57

3 - 12 DIFFERENTIAL AND DRIVELINE
DISASSEMBLY AND ASSEMBLY (Continued)
(2) Place a bearing assembly in a tube yoke hole
and over a trunnion. Keep the needle bearings
upright in the bearing assembly (Fig. 28). A needle
roller lying at the bottom will prevent proper assem-
bly. Be sure to remove any lube fittings that may
interfere with removal.
Fig. 28 Install Bearing Assembly
(3) Press the bearing assembly in place and install
a snap ring (Fig. 29).
Fig. 29 Press In Bearing Assembly
(4) Flip the tube yoke and bearing assembly instal-
lation on the opposite trunnion. Install a snap ring
(Fig. 30).
Fig. 30 Press In Bearing Assembly
(5) Fit the center yoke on the remaining two trun-
nions and press bearing assemblies in place, both
sides (Fig. 31). Install a snap ring.
Fig. 31 Install Center Yoke
ZJ