File Display; File Dump; Soft Switch Set; Touch Panel Adjustment - Konica Minolta bizhub 200 Service Manual

Field Service Ver. 2.5 Jul. 2006
8.3.3

File Display

Functions
• This displays the RAM data of MAIN-CPU on the LCD by specifying its file name.
* If enhance security mode is set ON, menu is not shown.
Use
1
1. Call the Maintenance Mode to the screen.
2. Touch the [File Display].
Setting/ 3. Type the file name from the 10-Key Pad or the keyboard on the screen and touch
Procedure [Enter].
4. Touch [ ] or [ ] to change the address to be displayed.
5. Touch the [Enter].
8.3.4

File Dump

Functions
• This outputs a report on the RAM data of MAIN-CPU by specifying its file name.
* If enhance security mode is set ON, menu is not shown.
Use
1
1. Call the Maintenance Mode to the screen.
2. Touch the [File Dump].
Setting/ 3. Type the file name from the 10-Key Pad or the keyboard on the screen and touch
Procedure [Enter].
4. Touch [ ] or [ ] to change the address to be displayed.
5. Touch [Enter], and the file dump sequence is started.
8.3.5

Soft Switch Set

Functions
• This sets up the soft switches for maintenance.
* If enhance security mode is set ON, menu is not shown.
Use
1
1. Call the Maintenance Mode to the screen.
2. Touch the [Mode Select].
3. Enter the mode number (a 3-digit numeral) from the 10-Key Pad.
Setting/ 4. Touch the [Bit Select].
Procedure 5. Align the cursor using [ ] or [ ] and define the bit using 0 or 1 of the 10-Key Pad. (To
set using hexadecimal numbers, touch [HEX Selection] and enter the data using the
10-Key Pad and A to F keys.)
6. Touch [Enter] twice.
8.3.6

Touch Panel Adjustment

Functions • To adjust the position of the Touch Panel.
Use • When the Touch Panel is slow to respond when touched
1. Call the Maintenance Mode to the screen.
2. Touch the [Touch Panel Adjustment].
3. Following the arrow, sequentially press four points (+) on the screen using a pen or
Setting/
similar object.
Procedure
NOTE
• Press the very center of each point.
• Use care not to allow the tip of the pen to damage the surface of the screen.
8. Maintenance Mode
31