Konica Minolta bizhub 200 Service Manual page 821

4. Other
[25]
[27]
[31]
[32]
<Rear>
<Front>
18
[26]
4511F2C545DA
[29]
[28]
4511F2C547DA
[30]
[34]
[33]
4511F2C548DA
[35]
[36]
4511F2C549DA
Field Service Ver. 1.0 Aug. 2005
12. Remove the gear [25] of Crease
Roller 2, and remove the Lower
Guide Plate [26].
NOTE
• When installing the gear [27] to the
Lower Guide Plate [28], insert the
gear [27] at an angle and use care
not to break the tabs [29].
• Install the Lower Guide Plate as
shown on the left.
13. Remove the screw [30].
14. Remove two C-rings [31], and
remove the Crease Roller A [32],
B [33], and C [34].
Precaution for Roller 1 and 2 Reinstal-
lation
• Install the rear gear [35] of Crease
Roller 2 so that it is above one gear
tooth.
• Align the mark [36] of the front gear.