Scan To Smb - Konica Minolta bizhub 200 Service Manual

12. Troubleshooting
12.2.9

Scan to SMB

2
Item No. Error Code
1 ED09C6
2 ED09C7
3 ED09C8
4 ED09C9
5 ED09CF
6 ED09CC
7 EF09CD
8 EF09D0
12.2.10 Scan to PC
2
Item No. Error Code
1 EAXXXX
196
Possible Cause
The LAN cable is not connected, or
the destination address is incorrect.
The user name or password is incor-
rect.
The specified folder does not exist.
The disk capacity is full.
The protocol is incorrect.
The protocol is incorrect.
Available memory is not sufficient.
Characters that cannot be used have
been entered.
Possible Cause
The IP address specified for the desti-
nation is wrong.
The power of the PC with the destina-
tion IP address is not turned ON.
ImageReceiver is not running.
The PC is receiving from another
scanner.
An IP address of a network multi-
function machine other than that of
the sender is set with the ImageRe-
ceiver settings of the PC with the des-
tination IP address.
The IP address of the destination is
not correctly set in the ImageReceiver
setting.
The IP address of the sender is not
set correctly in [Receive Settings] -
[Connection Filter].
The ImageReceiver is not operating
normally.
Field Service Ver. 2.5 Jul. 2006
Action to be Taken
Check that the LAN cable is correctly
connected. Also, check that the settings
for the destination address and port num-
ber are correctly specified.
Check the user name and password.
Check that the save destination folder
exists and check the folder name.
Free up the disk space on the corre-
sponding disk.
Ask the administrator to deactivate the
protocol usage restrictions, or look for
other delivery methods, or look for other
delivery methods.
Ask the administrator to deactivate the
protocol usage restrictions, or look for
other delivery methods.
Expand the memory of this machine.
Change the file name.
Action to be Taken
Set the IP address of the destination PC
again.
Confirm that the power of the PC is
turned ON and that ImageReceiver is
running.
Start up ImageReceiver.
Try transmission again after reception is
completed.
The network multi-function machine that
is the destination is fixed. To send from
the current network multi-function
machine anyway, delete the IP address
in the ImageReceiver setting and reboot
ImageReceiver.
Delete the IP address in the ImageRe-
ceiver setting and reboot ImageRe-
ceiver.
Set the IP address correctly in
[Receive Settings] - [Connection Filter]
setting, and reboot ImageReceiver.
Restart your PC.
Install IP Scanner again.
Check the TCP/IP settings of the PC.