Konica Minolta bizhub 200 Service Manual page 582

Field Service Ver. 2.5 Jul. 2006
Error
Error Details
Code
95 10-second timeout
after low-speed flag
detection during
image signal carrier
(HMCD ON) detection
waiting
96 15-second carrier dis-
connection during G3
image signal recep-
tion
97 • T2 timeout during
post message
reception waiting
• T2 timeout during
DCN reception
waiting after receiv-
ing last page
• No destination
response after
changing mode (T2
timeout)
98 DCN reception dur-
ing waiting for com-
mand other than DCN
in Phase D
99 PRI-Q reception for
port message (com-
munication result is
normal although error
code is set)
Possible Cause
Dest. Line Self
V.34 failure
Destination
machine failure
Line failure
(packet loss,
delay, etc.)
V.34 failure
Destination
machine failure
Line failure
(packet loss,
delay, etc.)
V.34 failure
Destination
machine failure
Line failure
(packet loss,
delay, etc.)
V.34 failure
Destination
machine failure
or disconnection
Line failure
(packet loss,
delay, etc.)
V.34 failure
Destination
machine failure
Line failure
(packet loss,
delay, etc.)
12. Troubleshooting
Action to be Taken
Set V.34 to OFF and the signal
transmission level to -16dBm, and
send again.
Change the destination machine
and send again.
Confirm the status of the network
(HUB connection, etc.)
Set V.34 to OFF and the signal
transmission level to -16dBm, and
send again.
Change the destination machine
and send again.
Confirm the status of the network
(HUB connection, etc.)
Set V.34 to OFF and the signal
transmission level to -16dBm, and
send again.
Change the destination machine
and send again.
Confirm the status of the network
(HUB connection, etc.)
Set V.34 to OFF and the signal
transmission level to -16dBm, and
send again.
Change the destination machine
and send again.
Confirm the status of the network
(HUB connection, etc.)
Set V.34 to OFF and the signal
transmission level to -16dBm, and
send again.
Confirm the status of the destina-
tion machine.
Confirm the status of the network
(HUB connection, etc.)
205