Konica Minolta bizhub 200 Service Manual page 131

6. Other
[3]
[5]
[8]
[9]
[12]
[13]
92
3. Remove two shoulder screws [3], the
screw [4], and the Exit Rolls 2 Assy
[4]
[5].
[3]
4040F2C643DA
4. Remove the wiring saddle [6] and
the harness.
[6]
4040F2C730DA
5. Disconnect the connector [7] of the
Exit Sensor and remove the Exit
Rolls 2 Assy [8].
[7]
4040F2C431DA
6. Remove the screw [9] and the Sepa-
ration Claw Assy [10].
[10]
4040F2C644DA
7. Remove four springs [11], the shaft
[11]
[12], and four Separation Claws [13].
4040F2C747DA
Field Service Ver. 2.5 Jul. 2006