Konica Minolta bizhub 200 Service Manual page 475

11. Soft Switch
Pattern 8 2:00 am on last Sunday, November
2
Pattern 9 2:00 am, April 1
2
Pattern 10 2:00 am, April 1
2
Pattern 11 <Until 2006>
2
2:00 am on 1st Sunday, April
<After 2007>
2:00 am on 2nd Sunday, March
MODE
Bit:
198
Bit Feature
7 TX forwarding to adminis-
trator <*>
6 TX forwarding of scanner
function to administrator
<*>
5 Result report TX forward-
ing to administrator
4
NOTE
• (*1): Bit 7 of mode 198 is enabled only when "1 (forwarded)" is specified.
100
Start Time
Factory setting bit
7 6 5 4 3 2 1 0
1 1 0 1 0 0 0 0
Logic
0 1
Not for- For-
warded warded
Not for- For-
warded warded
Bit 5-4: 00
01
10
11
Field Service Ver. 2.5 Jul. 2006
End Time
2:00 am on last Sunday, February
2:00 am on last Sunday, October
2:00 am, October 1
2:00 am on last Sunday, October
2:00 am on 1st Sunday, November
HEX:D0
Description
Specifies whether a received document
is forwarded to a destination specified by
the administrator.
Specifies whether to enable TX For-
warding when scanning. (*1)
Not output Specifies the print
conditions of trans-
Output for
mission reports for TX
incomplete TX
Forwarding. (*1)
Always output
Not available