Replace The Steering Wheel - Taylor-Dunn RE-380-36 Operator's And Service Manual

REPLACE THE STEERING WHEEL

6. If equipped with a horn switch in the steering wheel, remove the switch and disconnect the wires
from the switch.
7. Remove the steering wheel nut.
8. Using a steering wheel puller, remove the steering
wheel.
9. Position the front wheels in the straight ahead
position.
10. Lightly grease the steering wheel splines and install
the replacement steering wheel orientated as shown
in the illustration to the right.
11. Tighten the steering wheel nut to 50-60 ft-lbs
12. Reinstall the horn switch (if equipped).
13. Reconnect the main positive and negative cables
at the batteries.
14. Remove the blocks from behind the wheels.
15. Release the parking brake and test drive the vehicle.
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Steering Page 9