Taylor-Dunn RE-380-36 Operator's And Service Manual page 49

12. Thoroughly clean and/or replace all bearings, nuts, washers, and bushings.
NOTE: Both the left and right side bushings and thrust bearings should be
replaced as a set.
13. Assemble in reverse order.
14. Pack the thrust bearing with grease.
15. Tighten the king pin nut until there is 0.156 to 0.172 inch clearance as shown in the illustration
below.
NOTE: Refer to
regarding proper tightening of the spindle nut
16. Install new cotter pins.
17. Realign the wheels.
NOTE: Refer to the
of the front wheels.
18. Lower the vehicle.
19. Reconnect the main positive and negative cables at the batteries.
20. Remove the blocks from behind the wheels.
21. Release the park brake and test drive the vehicle.
Axle Beam
.156
.172
VISUAL GAP
Maintenance, Service, and Repair
Replace Front Wheel Bearings
Steering
section for information regarding realignment
Front Axle Page 15
for information
Thrust Bearing