Taylor-Dunn RE-380-36 Operator's And Service Manual page 179

Charger Models:
HBS 600
HBS 1000
TABLE OF CONTENTS
Definitions: ............................................2
Test Equipment Required for
Troubleshooting ...............................2
Important Notes and Instructions
Operating Instructions and Theory of
Operation ........................................3
Testing the Charging Cycle ....................4
Status Light Error Code Table................5
Troubleshooting .....................................6
Turn the Key switch OFF BEFORE
disconnecting the batteries. Disconnecting
the batteries with the key switch ON may
corrupt the controller programming
resulting in a fault code 1 (refer to fault
table).
GEL batteries must be charged with a charger configured for
GEL batteries. Use of any other charger will result in damage
to the batteries and premature failure of the batteries.
Rev C
2