Rear Hub Or Rotor - Taylor-Dunn RE-380-36 Operator's And Service Manual

REAR HUB OR ROTOR

NOTE: The torque specification for the axle hub bolt is 275 ft-lbs. An impact
NOTE: The axle hub bolt has a special thread locking compound applied
6. Raise the wheel off of the ground.
7. Remove the tire/wheel assembly, Refer to
regarding removing the tire/wheel assembly.
8. Remove the axle hub bolt and washer
and remove the hub from the axle.
9. Remove the outer brake pad. Refer to
Brake Service
section
regarding removing the brake pads.
10. Remove the rotor.
11. Install in reverse order.
a. Lightly grease the axle splines.
b. Refer to section
c. Thoroughly clean the threads in the axle shaft.
d. Using a new bolt, torque the axle hub bolt to 275 ft-lbs.
Tires and Wheels
e. Refer to
12. Lower the wheel to the ground.
10. Reconnect the main positive and negative cables at the batteries.
11. Remove the blocks from behind the wheels, release the park brake and test drive the vehicle.
Maintenance, Service, and Repair
wrench will be required to remove the bolt.
to the threads. If this bolt is removed, it must be replaced.
1. Make sure the key-switch is in the "OFF" position, then remove the
key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
for information
Brake Service
for information regarding installing the brake pads.
The axle retaining plate bolts have a pre-applied thread locking
compound. They are intended for one time use only. If removed they
must be replaced. Reusing the original bolts could cause loss of brakes
resulting in severe bodily injury and/or property damage.
Rear Brakes
Refer to section
of the bolt.
section for information regarding installing the tire/wheel assembly.
Transmission
Tires and Wheels
section for information
Illustrated Parts
in
Page 5
for the part number