Recorder Bootup Sequences; Standard Bootup Sequence (Without Any Card Inserted); Table 2-5 Standard Bootup Sequence (Without Any Card Inserted) - Zaxcom ZFR100 User Manual

Chapter 2____________________________________Zaxcom Miniature Digital Recorder User's Manual

Recorder Bootup Sequences

Standard Bootup Sequence (without any card inserted)

LCD
SYNTH AB
LOWER POWER MODE
IFB IS OFF
PCB REVB
VER A-AAA (CC)
***NO CARD***
NAME:
DDDDDDDD
ENCRYPTION IS ON
AUDIO
ZAXCOM
WWWWWW
STOP 00:00:00:00
000:
LOW BATTERY
1.60V
(OPTIONAL PAGE: Only appears if Low Power mode is fully enabled.)
0
BBBB PCB REVB
(
A–AAA
(
BBBB
(
CC
(
DDDDDDDD
(
The initial default is "
(OPTIONAL PAGE: This statement indicates that an encryption code
has been entered. Verify the code matches the associated receiver‟s code.)
VA-AAA
WWWWWW
(
SN:ZZZZZ
ZZZZZ
(
(This page appears, when the battery HAS to be changed.)

Table 2-5 Standard Bootup Sequence (without any card inserted)

– Indicates the printed-circuit board is revision "B".)
– Indicates the currently installed firmware version.)
– Programmable logic device revision code.
„0000‟=no timecode input „0150‟=timecode input available.)
– Indicates which options are available:
00=none, 01=Record, 02=IFB, 03=IFB & Record.)
– Displays the "Name" entered in the Extended Menu.
SN:
", followed by the unit‟s serial number.)
– Indicates what hardware is being initialized.)
– Indicates the unit‟s serial number.)
(Be aware, if you get this alert,
the unit will not go into RECORD mode.)
18