Section 9 - Steering And Front Suspension; General Information; Steering Wheel; Steering Wheel Removal - Club Car 2008 Turf Maintenance And Service Manual

SECTION 9 – STEERING AND FRONT SUSPENSION
ý
DANGER
• See General Warning, Section 1, Page 1-1.
ý
WARNING
• See General Warning, Section 1, Page 1-1.

GENERAL INFORMATION

Steering is controlled through a rack and pinion steering assembly that is connected by a steering column to
a steering wheel. No manual adjustment to the rack and pinion gear assembly is required. A spring loaded
self-adjusting mechanism is incorporated into the assembly.

STEERING WHEEL

See General Warning, Section 1, Page 1-1.

STEERING WHEEL REMOVAL

1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 1, Page 1-2.
2. Remove the two mounting screws (30) and plate (28) (Figure 9-3, Page 9-3).
3. Match mark the steering wheel (25) and steering column shaft (19) so when the steering wheel is
removed it can be placed back in exactly the same position on steering column shaft (Figure 9-3,
Page 9-3).
4. Loosen the steering wheel nut (27) and back it off approximately 1/4 inch (6 mm). Do not remove the nut
(Figure 9-3, Page 9-3).
5. Use the steering wheel puller (CCI P/N 102061201) to remove steering wheel.
5.1. Place the puller anvil (4) through the top opening of the steering wheel (Figure 9-1, Page 9-2).
5.2. Insert the anvil feet through the two slots in the base plate (marked "B") (5) as shown (Figure 9-1,
Page 9-2).
5.3. Rotate the anvil screw (6) clockwise until the base plate contacts the bottom of the steering wheel
where it attaches to the steering column (Figure 9-2, Page 9-2).
5.4. Using a 1/2-inch drive air impact wrench, tighten the anvil screw (6) until the steering wheel breaks
free from the steering shaft.
2008 Turf/Carryall Vehicle Maintenance and Service Manual
9
Page 9-1